Multi-receiver unit CM-5000
The multifunctional talent ... special operating modes for standard servos are tailored to the requirements of functional model building. For example, there is a mode to operate a servo like a hydraulic cylinder: when you let go of the stick, it stops in its current position. This can also be expanded to a windshield wiper using the interval switch. The speed of rotation of servos (also in normal operation) can be adjusted to achieve particularly realistic motion sequences. Freely programmable mixers can be used to implement special functions, such as the correct steering of tracked vehicles, end shutdown of drives, delayed response or any route curves.
The programmable control (PLC) optionally integrated in the receiver also allows the individual implementation of processes that would otherwise only be possible with complex additional modules.
The central unit for the light bus system is firmly integrated in all Scaleart receivers. This enables customizations, such as Programmable flashing cycle and automatic flashing reset after turning, adjustable response thresholds for cornering and turning lights or dependencies between vehicle lighting and operating status.
The CM-5000 offers complete equipment: Connections for 16 servos, two temperature or pressure sensors and the bus lighting system. An integrated position sensor determines incline or decline as well as side slope. To operate hydraulic pumps or power take-offs, there is a controller that can be loaded with 4 amps. The receiver can also monitor the energy supply for the entire model: an integrated sensor measures the current drawn from the battery and determines the capacity used. There is also an infrared output, which enables convenient operation with trailers or semitrailers that have a lighting system from Scaleart or Robbe. The CM-5000 measures 63x41mm, the remote antenna 40x17mm. If more connections are required, up to 8 of these receivers can be operated on a common antenna in the model. The HF antenna is required!
Function overview of the multi-receiver unit CM-5000
- Servo slots: 16
- Can be used for switching functions: 16
- Can be used as an input: 8
- Function blocks (mixer): 16
- Light bus control: yes
- IR output: Compatible with Robbe and Scaleart
- Integrated controller for power take-offs: Up to 3 amps, with overcurrent, short-circuit and temperature protection
- Control of Mulitswitsch modules: 1 compatible with Graupner, Robbe and ScaleART
- Measurement of battery voltage: yes
- Measurement of current consumption: yes
- Battery management with reverse polarity protection: Loadable up to 12 amps, maximum operating voltage 18 volts
- Additional sensor connections: 2
- Position sensor: incline and slope
- Adjustable alarm thresholds: Individual minimum or maximum values ??for all measured values
- Hydraulic pump control: max. 32 functions monitored
- Mixer for tracked vehicles: yes
- Limit switch-off via position sensor: yes
- Undervoltage protection: yes
- Controller current limitation: yes
- Sequential transmission control: up to 4 gears
- Free route template: yes
- Brake light function: yes
- Smoke generator control: yes
- Resettable hour meter: 4
- Servo setting time adjustable: 0-20 seconds
- Adjustable servo travel: 0-200% right and left separately
- Hydraulic simulation for servos: yes
- Programmable sequence control: yes *)
- Password protection: Separate for operation and configuration
- Power supply: BEC or drive battery, 4.8 to 18 volts
- Bus-compatible (several evaluators in the model): yes
- Software update possible in the model: yes
- Dimensions: 63x41mm
*) Sequence control can only be configured with Commander SA-1000 / SA-5000
